• Compatible with Arduino boards that have the 1.0 Shield interface (UNO R3) including, but not limited to:
  • Arduino Zero
  • Arduino Uno
  • Arduino Mega
  • Arduino Leonardo
  • Arduino Due
• Supports 5V and 3.3V main boards through the IOREF pin (defaults to 5V if this pin is absent)
• Supports direct connection to the PC on main boards with a separate USB/Serial chip and a special software-driven “bridge mode” on boards with only native USB interface, for easy access and configuration with the EasyVR Commander
• Enables different modes of serial connection and also flash updates to the embedded EasyVR module (through the Mode Jumper)
• Supports remapping of serial pins used by the Shield (in SW mode)
• Provides a 3.5mm audio output jack suitable for headphones or as a line out

EasyVR Shield 3 fully assembled